A-Monitor Select Button
B-Monitor Display
C-Engine Coolant Temperature Gauge
D-Fuel Level Gauge
E-Hydraulic Oil Temperature Indicator

F-Hydraulic Oil Filter Restriction Indicator
G-Transmission Oil Filter Restriction Indicator
H-Transmission Oil Temperature Indicator
I-Engine Air Cleaner Restriction Indicator

J-Engine Alternator Voltage Indicator
K-Engine Oil Pressure Indicator
L-STOP Indicator
M-Service Required Indicator
N-Differential Lock Indicator

O-Check Service Code Indicator
P-Secondary Steering Indicator-If Equipped
Q-Fasten Seat Belt Indicator
R-Park Brake Indicator

The monitor has a display window, two gauges, two service indicators, and 12 function indicators. The monitor displays service codes sent by the transmission controller.

The display monitor has three modes of operation:

• KEY OFF MODE: With battery disconnect switch ON and key OFF, pressing the SELECT button displays information on the monitor display. Repeatedly pressing the SELECT button cycles the display between two display modes. Pressing and holding the SELECT button cycles between modes at four second intervals. The engine coolant temperature

gauge and fuel tank level gauge remain backlit while the SELECT button and monitor display are in use. When the SELECT button is released, unswitched power is removed and information is no longer displayed.
• BULB CHECK MODE: With battery disconnect switch ON and the engine not running, turning the key switch ON puts the display monitor in bulb check mode. In this mode, the monitor alarm sounds and all indicator lights glow, including stop indicator (L) and service required indicator (M). Bulb check mode lasts five seconds, to allow the operator time to verify that all display elements are functional.

CED,OUO1079,43 -19-29MAR00-1/2

• ENGINE RUNNING MODE: Monitor enters engine running mode when it detects engine oil pressure and frequency from the alternator. In engine running mode, monitor displays status of machine functions through its indicators and gauges. Repeatedly pressing the SELECT button cycles the display between four display modes. Pressing and holding the SELECT button cycles between modes at four second intervals.

FOUR MONITOR DISPLAY MODES:

The following monitor display modes are accessed by pressing the SELECT button when the monitor panel is in engine running mode:

• Hour Meter
• Battery Voltage Indicator
• Transmission Gear Position
• Engine rpm

Only the hour meter and battery voltage indicator display modes can be accessed in key OFF mode.

CED,OUO1079,43 -19-29MAR00-2/2