|
IMPORTANT:
If hydraulic and hydrostatic oil is cold, functions move slowly. Do not attempt normal machine operations until hydraulic and power train functions move at close-to-normal cycle times.
1.
Start engine. Run engine at minimum speed for 5 minutes.
2.
Cycle boom and bucket functions until functions move at normal speed.
3.
Cycle steering from left to right at least five times, until steering functions normally.
|
Prepare machine to shift machine as follows:
-
Machine-stopped
-
Engine-slightly above low idle
-
Bucket-off the ground and empty
-
Brakes-apply brakes, using inching pedal
-
Park brake-released
-
Cycle hydrostatic system 10 times by shifting from forward (F) to neutral (N) to reverse (R) and back to neutral (N). Each cycle should be approximately 5 seconds.
-
Repeat until power train operates normally.
|