Loading Machine on a Trailer

1. Keep the trailer bed clean. Put chock blocks against trailer wheels.

2. Use a ramp or loading dock. Ramps must be strong enough, have a low angle, and correct height.

3. Fasten seat belt before starting engine.

causym CAUTION: Position the machine so that its centerline is over the centerline of the truck bed. NEVER steer the machine while on the ramp. If changing direction is required on the ramp, unload the machine from the ramp, reposition the machine on the ground, then try loading again.

4. Drive the machine onto the ramp slowly. The centerline of the machine should be over the centerline of the trailer.

5. Lower all equipment onto blocks or trailer bed.

CED,OUO1002,419 -19-14OCT99-1/2

6. Move FNR lever (A) to neutral (N). Engage neutral lock latch (B).

causym CAUTION: Prevent possible injury from unexpected machine movement. Never rely on FNR lever alone to keep machine from moving. Machine can unexpectedly roll or move under power, resulting in death or serious injury. Always turn off engine or push park brake switch to ON to hold machine.

7. Push park brake switch to ON.

8. Install frame locking bar.

9. Turn key switch to STOP.

10. Cover exhaust opening to prevent entry of debris or water.

11. Fasten each corner of the machine to the trailer with a chain or cable with appropriate load binder.

12. Place blocks in front and behind tires.

T113086


A-FNR Lever
B-Neutral Lock Latch

CED,OUO1002,419 -19-14OCT99-2/2