Clean Cab Air Filter

NOTE: Access to the cab air filter is located outside on left rear corner of cab.

1. Remove cap screw (A) and filter cover (B).

2. Remove cap screw (D), bracket (E), and air filter (C).

causym CAUTION: Reduce compressed air to less than 210 kPa (2 bar) (30 psi) when using for cleaning purposes. Clear area of bystanders, guard against flying chips, and wear personal protection equipment, including eye protection.

3. Service filter in one of these ways:

  • Tap it on a flat surface with the dirty side down.
  • Use compressed air opposite to the normal air flow.
  • Replace filter.

4. Install filter (C), bracket (E), and cap screw (D).

5. Install filter cover (B).

6. Install cap screw (A) and tighten.


A-Cap Screw
B-Filter Cover
C-Air Filter
D-Cap Screw
E-Bracket

T113135
T113136

CED,OUO1002,442 -19-20FEB98-1/1