Park Brake Adjustment

causym CAUTION: Prevent possible injury from unexpected movement. Place blocks at front and rear tires to prevent machine from rolling.

IMPORTANT: Park brake adjustment must be performed with the brakes cold.

1. Remove cap (A) from park brake.

2. Start engine and leave in neutral. Release park brake.


A-Park Brake Cap

T113098

CED,OUO1002,479 -19-23FEB98-1/3

3. Loosen lock nut (C).

4. Using a 8 mm (0.315 in.) hex wrench (B) with the short end cut to 22 mm (0.875 in.), turn adjusting screw (D) clockwise until brake pads make contact with brake disk.

5. Turn adjusting screw (D) counterclockwise one-half turn. The gap between the disk and pads must be to specification. Adjust as necessary.

Specification

Park Brake Disk-to-Pad -Gap 1.0 ± 0.5 mm (0.039 ± 0.019 in.)

6. Hold the adjusting screw (D) in position with hex wrench and tighten lock nut (C) to specification.

Specification

Park Brake Lock Nut -Torque 40-70 N·m (29.5-51.6 lb-ft)
Park Brake Pad -Thickness 1.5 mm (0.059 in.) Minimum
Service Brake Pads -Thickness 2.0 mm (0.079 in.) Minimum


B-Hex Wrench
C-Lock Nut
D-Adjusting Screw

T113104
T113100

CED,OUO1002,479 -19-23FEB98-2/3

7. Install cap (A) and tighten by hand.


A-Park Brake Cap

T113098

CED,OUO1002,479 -19-23FEB98-3/3