Service Intervals

SERVICE INTERVALS
Service your machine at intervals shown on this chart. Also, perform service on items at multiples of the original requirement. For example, at 500 hours also service those items (if applicable) listed under 250 hours, 100 hours, 50 hours and 10 hours or daily.
As Required
· Drain fuel tank sediment · Lubricate door, engine cover, and engine access door hinges
· Inspect serpentine belt · Inspect tires and check pressure
· Drain fuel filter sediment · Tighten wheel lug nuts
· Clean or replace air cleaner elements  
Every 10 Hours or Daily
· Check coolant level · Clean air cleaner dust unloader valve
· Check engine oil level · Check hydraulic oil level
Every 50 Hours
· Lubricate loader linkage and cylinder pivots · Lubricate rear axle knuckle joint
· Lubricate gearbox to front axle shaft  
Every 100 Hours
· Lubricate front and rear steering cylinder pivots · Lubricate frame hinge pivot
· Lubricate oscillating rear axle  
Oil Sampling
Oil samples should be taken from each system prior to its recommended drain/change interval indicated on this form. Maintenance recommendations supplied by OILSCAN will be provided based upon the oil analysis and operating information you supply. Regular oil sampling will extend the operational life of your machine's systems.
Every 250 Hours
[ ] Clean cab air filter [ ] Drain and refill engine oil
[ ] Replace engine oil filter [ ] Check brake oil level
Comments:

Date:
Hour Meter Reading:
Maintenance Performed By:
Every 500 Hours
   
[ ] Check coolant conditioner [ ] Check air intake hose
[ ] Lubricate rear steering axle pivots [ ] Replace hydraulic oil return suction filter
[ ] Check and clean hydraulic oil cooler and radiator [ ] Check battery water level and tighten terminals
[ ] Replace fuel filter [ ] Check brake/inching pedal linkage adjustment
[ ] Check front and rear axle oil level  
Comments:

Date:
Hour Meter Reading:
Maintenance Performed By:
Every 1000 Hours
[ ] Check service and park brake pads [ ] Replace air cleaner elements
[ ] Replace cab air filter [ ] Replace air cleaner dust unloader valve
[ ] Speed control linkage adjustment [ ] Replace hydraulic tank breather
[ ] Change rear differential oil [ ] Change rear final drive oil
[ ] Check and adjust engine valve lash [ ] Change front differential and final drive oil
[ ] Clean engine crankcase vent tube  
Comments:

Date:
Hour Meter Reading:
Maintenance Performed By:

 

CED,OUO1002,575 -19-15NOV01-1/2


Every 2000 Hours
[ ] Clean hydraulic oil return strainer [ ] Change hydraulic system oil
Comments:

Date:
Hour Meter Reading:
Maintenance Performed By:
       
REQUIRED PARTS
Ensure machine performance and availability; use only genuine John Deere parts. Verify part numbers are current and that any associated parts are also on hand i.e. filter O-rings.
  Part Number ASI 250 HOURS 500 HOURS 1000 HOURS 2000 HOURS
Engine Oil Filter RE59754 1 1 1 1 1
Fuel Filter RE60021 1   1 1 1
Hydraulic System Return Suction Filter AT219080     1 1 1
Engine Air Filter, Primary AT203469       1 1
Engine Air Filter, Secondary AT203470       1 1
Cab Air Filter AT219128       1 1
Hydraulic Reservoir Breather AT219006       1 1
John Deere PLUS-50® Oil   12 L (13 qt) 12 L (13 qt) 12 L (13 qt) 12 L (13 qt) 12 L (13 qt)
HY-GARD® Transmission and Hydraulic Oil            
324H         20 L (5.25 gal) 85 L (22 gal)
344H         23 L (6 gal) 88 L (23 gal)
Coolant Conditioner TY16004 As Needed
OILSCAN PLUS® Test Packages:  
·Diesel Engine Oil AT178840   1 1 1 1
·Front and Rear Axle Differentials AT178840     2 2 2
·Hydraulic & Hydrostatic System Oil AT178844     1 1 1
CoolScan Plus® AT183016     1 1 1
Service Brakes Oil SAE10W          

 

PLUS-50 is a trademark of Deere & Company
HY-GARD is a trademark of Deere & Company
OILSCAN PLUS is a trademark of Deere & Company
CoolScan Plus is a trademark of Deere & Company

CED,OUO1002,575 -19-15NOV01-2/2