Stopping the Engine
IMPORTANT:
If engine stops when operating under load, remove load. Restart engine immediately. Run for 30 seconds at 1/2 speed before adding load.
1.
Park machine on a level surface.
2.
Lower front-mounted equipment to ground.
3.
Push park brake switch to ON to engage park brake.
IMPORTANT:
Turbocharger may be damaged if engine is not properly shut down.
4.
Run engine at 1/2 speed for 2 minutes before stopping to avoid damage to turbocharger.
5.
Move engine speed control knob to slow idle position.
6.
Turn key switch OFF. Remove key from switch.
|