Prepare Machine for Maintenance
Before performing maintenance procedures given in the following chapters and before leaving the operator's seat, park the machine as described below unless another position is specified in the procedure.
1.
Park machine on a level surface.
2.
Lower front-mounted equipment to ground.
IMPORTANT:
Turbocharger may be damaged if engine is not properly shut down.
3.
Run engine at 1/2 speed for 2 minutes before stopping to avoid damage to turbocharger.
4.
Move engine speed control knob to slow idle position.
5.
Turn key switch OFF. Remove key from switch.
6.
Move battery disconnect switch to OFF position.
7.
Raise armrest to shut off pilot control pressure.
8.
Attach a "Do Not Operate" tag to the right control lever.
|