|
1.
Keep trailer bed clean. Put wheel chocks against trailer wheels.
2.
Use a ramp or loading dock. Ramps must be strong enough, have a low angle, and correct height. Load and unload machine on a level surface.
3.
Fasten seat belt before starting engine. Allow engine to run for several minutes.
4.
Install the extendible dipperstick locking pin, if equipped, and engage the backhoe swing lock.
5.
Drive the machine up ramps slowly with centerline of machine over centerline of trailer.
6.
Lower loader bucket onto blocks or trailer bed.
7.
Lower backhoe boom until bucket rests on trailer bed.
|
8.
Stop engine.
IMPORTANT:
Prevent possible hydraulic system damage. Fasten chains or cables to machine at proper locations.
9.
Fasten chains or cables from trailer to frame tie-downs. Do not route chains or cables over or against hydraulic lines or hoses.
10.
Fasten backhoe bucket to trailer with chains or cables to prevent movement during transport.
11.
Cover engine exhaust pipe opening with tape to keep dust and rain out of pipe.
|