Starting Fluid-Cold Weather Start Aid (S.N. 882700-)

CAUTION: Prevent possible injury from exploding container. Starting fluid is highly flammable. Keep container away from heat, sparks, and open flame. Contents are pressurized. Do not puncture or incinerate container. Remove can from machine if engine does not need starting fluid.

IMPORTANT: Remove container and install plug in base to protect start aid components from dust.

Prevent damage to engine. Use starting aid when temperatures are below 0°C (32°F) and only when engine is COLD.

IMPORTANT: To avoid engine damage, push and hold start aid button only when engine is cold and cranking. Starting fluid is being injected into engine as long as the start aid button is held.

NOTE: Crank engine for 30 seconds maximum, allowing 2 minutes between cranking periods.

While cranking engine, push start aid button (A).

A-Start Aid Button

OUO1030,0000746 -19-20MAR07-1/2

2. Loosen hose clamp (B).

3. Turn start aid container (C) counterclockwise to remove.

4. Remove safety cap from new container.

5. Turn container clockwise in starting aid base to install.

6. Tighten hose clamp.

7. Close engine hood.

IMPORTANT: Protect start aid components from possible damage. Install start aid plug in start aid base.

Remove container and install plug (D) in base.

B-Clamp
C-Start Aid Can
D-Plug

OUO1030,0000746 -19-20MAR07-2/2