Monthly Storage Procedure

causym CAUTION: Prevent possible injury from asphyxiation. Engine exhaust fumes can cause sickness or death. Start engine ONLY in a well-ventilated area.

1. Drain water and sediment from fuel tank when air temperature is above freezing.

2. Remove LPS 3™ Rust Inhibitor from cylinder rods with a cleaning solvent.

T6191AA

TX,105,BG538 -19-03AUG07-1/3

IMPORTANT: Prevent possible engine damage. During cold temperatures, check fluidity of engine oil on dipstick. If the oil appears waxy and/or jelly-like rather than liquid, DO NOT attempt to start engine. Use external heat source to warm the crankcase until oil appears fluid.

3. Check all fluid levels. If low, check for leaks and add oil as required.

4. Check belts.

5. Check condition of all hoses and connections.

6. Check electrolyte level. Charge and install battery.

7. Check condition of tires. Check tire pressure.

8. Fill fuel tank. See Diesel Fuel. (Section 3-1).

9. Start engine. Run at 1/2 speed for five minutes. Do not run at fast or slow idle.

10. Bleed fuel system. If engine fails to start or runs poorly after starting, change fuel filter(s). Bleed fuel system again.

T6181AU

TX,105,BG538 -19-03AUG07-2/3

11. Make sure that area is clear to allow for machine movement. Operate (cycle) loader boom and bucket, and three-point hitch functions for three complete cycles.

12. Park the machine with cylinder rods retracted.

13. Apply LPS 3 Rust Inhibitor to exposed cylinder rod areas.

T106785

TX,105,BG538 -19-03AUG07-3/3