Towing

IMPORTANT: Engine cannot be started by towing. Damage to transmission may result. DO NOT tow machine faster than 10 km/h (6.21 mph) or any longer than 1 hour.

Towing IS NOT recommended. If you MUST tow machine, use the following procedure:

CAUTION: Prevent possible injury or death from unexpected machine movement. Block wheels to prevent machine movement before disengaging park brake.

2. Block tires.

CAUTION: Prevent possible injury or death from unexpected machine movement. Only release the park brake through the access hole in floor of operator's station

IMPORTANT: To avoid damage to park brake assembly from heat build-up, brake must be manually disengaged.

NOTE: When turning cap screws, turn one screw 1/2 turn, then the other, and continue to alternate between cap screws.

3. Remove access plate on floor to access park brake.

4. Move transmission control lever (TCL) and gear shift levers to neutral.

5. Release park brake for tow by turning cap screws (A) completely in. Loosen hex nuts (B) to adjust park brake screws (A).

6. Remove blocks from tires.

7. When towing is completed, block tires and enable park brake to hold machine by turning both cap screws out to specification (C) as illustrated.

A-Cap Screws
B-Hex Nuts
C-Cap Screw Specification

TX,40,BG474 -19-20FEB07-1/2

Specification

8. Tighten hex nuts (B) to lock cap screws in position.

TX,40,BG474 -19-20FEB07-2/2