Change Engine Oil and Replace Filter (S.N. -882699)

IMPORTANT: If fuel sulfur content exceeds 0.5 percent, change engine oil at one-half the normal interval.

If engine has not run 250 hours before the season changes, change oil.

2. Remove drain plug (A). Allow oil to drain.

3. Using a suitable filter wrench, turn filter (B) counterclockwise and remove from base. Clean mounting surfaces of base as necessary.

4. Apply a thin film of oil to sealing on new filter and install by turning new filter clockwise by hand until gasket touches mounting surface. Then torque an additional 1/2-3/4 turn with wrench.

5. Install drain plug.

6. Remove filler cap (C) and fill engine with 8.5 L (9.0 qt) of new oil. See Diesel Engine Oil. (Section 3-1.)

Specification

IMPORTANT: Before starting engine after a filter change, crank engine for 10 seconds without starting to refill filter and pre-lubricate engine.

7. Start engine and run at a slow idle. If engine oil pressure light on monitor does not go out and alarm shut off, stop engine immediately and find the cause.

8. Stop engine, check for leaks around drain plug and filter, and tighten filter as necessary. Check oil level. See Check Engine Oil Level. (Section 3-4.)

A-Engine Oil Drain Plug
B-Engine Oil Filter
C-Engine Oil Filler Cap

TX,75,BG497 -19-07MAR07-1/1