Replace Hydraulic Oil Filter and PTO Filter-If Equipped (S.N. -888003)1. Turn filters (A and C) counterclockwise and remove.2. Apply film of oil to sealing ring on new filter. Install until it touches mounting surface and tighten an additional 3/4 to one turn with a suitable wrench. 3. Check hydraulic oil level at sight gauge (B). 4. Start engine and run for 2 minutes to allow filter element to refill and purge air from charge circuit. 5. Stop the engine, check hydraulic oil level, and add as necessary. 6. Check for leakage around filter. Tighten filter just enough to stop leaks.
|
|
VD76477,0001430 -19-02MAR07-1/1 |