Replace Fuel Filter

NOTE: Dispose of waste properly.

2. Remove fuel drain knob (C) from filter element and install to new filter.

3. Clean filter base (D).

NOTE: Do not attempt to turn filter element into base.

4. Install new fuel element by aligning vertical locators (F) into slots (E) on filter base. Push filter element up firmly until filter snaps against base.

5. Turn retaining ring clockwise into filter base until retaining ring clicks tightly into place.

6. Loosen bleed screw (G) by turning knob counterclockwise.

7. Operate primer lever (H) until fuel flow from bleed screw is free of air bubbles.

NOTE: If there is no fuel flow, push primer lever toward engine and turn crankshaft using starter motor to reposition camshaft. Repeat step 6.

8. Tighten bleed screw.

9. Push primer lever toward engine as far as possible.

A-Locking Ring
B-Filter
C-Drain Knob
D-Filter Base
E-Slots
F-Vertical Locators
G-Bleed Screw
H-Primer Lever

VD76477,0001431 -19-19FEB07-1/1