Service Intervals (S.N. 888004-)

SERVICE INTERVALS
Service your machine at intervals shown on this chart. Also, perform service on items at multiples of the original requirement. For example, at 500 hours also service those items (if applicable) listed under 250 hours, 100 hours, 50 hours, and 10 hours or daily.
 
As Required
 
· Clean/replace engine air cleaner elements · Inspect belt
· Drain water and sediment from fuel tank · Lubricate draft link wear plates
· Inspect tires and check pressure · Clean air cleaner dust unloader valve
· Drain water and sediment from water separator · Check wheel fastener torque
· Lubricate MFWD drive shaft spline (if equipped)  
 
Every 10 Hours or Daily
 
· Check engine oil level · Lubricate 3 point hitch pivot points
· Check hydraulic reservoir oil level · Lubricate front axle pivot
· Check coolant level · Lubricate multipurpose (4-in-1) bucket (if equipped)
· Lubricate loader pivot points · Lubricate MFWD front axle U-joints
 
Every 50 Hours
   
· Check transmission oil level  
 
Initial Service - 250 Hours*
   
· Change engine break-in oil and replace filter  

 

* Perform initial service once after the first 250 hours of operation.

VD76477,0001460 -19-12APR07-1/3


Model: 210LE Customer:
PIN/Serial Number:
Delivery Date:
Hour Meter Reading:
OIL SAMPLING
Oil samples should be taken from each system prior to its recommended drain or change interval indicated on this form: 250, 500, 1000 hours. Maintenance recommendations supplied by OILSCAN PLUS™ will be provided based upon the oil analysis and operating information you supply. Regular oil sampling will extend the operational life of your machine's systems.
 
Every 250 Hours
 
[ ] Check MFWD front axle housing oil level [ ] Check rear axle oil level
[ ] Check MFWD planetary housing oil level [ ] Check battery electrolyte level and terminals
[ ] Take engine oil sample [ ] Take hydraulic oil sample
 
Comments:

Date:
Hour Meter Reading:
Maintenance Performed By:
 
Every 500 Hours
 
[ ] Check air intake hose [ ] Replace fuel filter
[ ] Drain and refill engine oil and replace filter [ ] Check coolant conditioner
[ ] Take diesel fuel sample [ ] Inspect and clean hydraulic reservoir fill screen and breather screen
[ ] Take front and rear axle gearbox oil samples [ ] Take engine coolant sample
[ ] Take transmission oil sample  
 
Comments:

Date:
Hour Meter Reading:
Maintenance Performed By:
 
Every 1000 Hours
 
[ ] Clean engine crankcase vent tube [ ] Drain and refill transmission and torque converter oil
[ ] Replace hydraulic oil filter and PTO filter (if equipped) [ ] Replace engine air filter elements
[ ] Replace transmission oil filter [ ] Check engine speed
 
Comments:

Date:
Hour Meter Reading:
Maintenance Performed By:
 
Every 2000 Hours
 
[ ] Adjust engine valve lash [ ] Drain and refill MFWD front axle housing oil
[ ] Drain and refill MFWD planetary housing oil [ ] Drain and refill hydraulic reservoir oil
[ ] Drain and refill rear axle and planetary oil  
 
Comments:

Date:
Hour Meter Reading:
Maintenance Performed By:
 
Every 5000 Hours
 
[ ] Drain and refill engine coolant  

 

OILSCAN PLUS is a trademark of Deere & Company

VD76477,0001460 -19-12APR07-2/3


 
Comments:

Date:
Hour Meter Reading:
Maintenance Performed By:

 

VD76477,0001460 -19-12APR07-3/3