| · Check loader boom lock |
· Inspect belt |
| · Drain water and sediment from fuel tank |
· Lubricate draft link wear plates |
| · Inspect tires and check pressure |
· Clean air cleaner dust unloader valve |
| · Check park brake |
· Lubricate non-powered axle wheel bearings (if equipped) |
| |
| Every 10 Hours or Daily |
| |
| · Check engine oil level |
· Lubricate 3 point hitch pivot points |
| · Check hydraulic reservoir oil level |
· Lubricate lift cylinder pivot points |
| · Check coolant level |
· Lubricate MFWD drive shaft spline (if equipped) |
| · Lubricate loader pivot points |
· Lubricate MFWD front axle U-joints (if equipped) |
| · Lubricate front axle pivot |
· Lubricate non-powered front axle steering pivot points (if equipped) |
| · Lubricate multipurpose (4-in-1) bucket (if equipped) |
|
| |
| Initial Service - 100 Hours* |
| |
|
| · Change engine break-in oil and replace filter |
· Change transmission and torque converter oil and replace filter |
| Model: 210LE |
Customer:
|
PIN/Serial Number:
|
Delivery Date:
|
Hour Meter Reading:
|
| OIL SAMPLING |
| Oil samples should be taken from each system prior to its recommended drain or change interval indicated on this form: 250, 500, 1000 hours. Maintenance recommendations supplied by OILSCAN PLUS™will be provided based upon the oil analysis and operating information you supply. Regular oil sampling will extend the operational life of your machine's systems. |
| |
| Every 250 Hours |
| |
| [ ] Drain and refill engine oil and replace filter (S.N. -882699) |
[ ] Check rear axle oil level |
| [ ] Check MFWD front axle housing oil level (if equipped) |
[ ] Check battery electrolyte level and terminals |
| [ ] Check MFWD planetary housing oil level (if equipped) |
[ ] Check transmission oil level |
| [ ] Take engine oil sample |
[ ] Take hydraulic oil sample |
| |
Comments:
|
|
Date:
|
Hour Meter Reading:
|
Maintenance Performed By:
|
| |
| Every 500 Hours |
| |
| [ ] Check air intake hose |
[ ] Replace fuel filter |
| [ ] Drain and refill engine oil and replace filter (S.N. 882700-888003) |
[ ] Inspect and clean hydraulic reservoir fill screen and breather screen |
| [ ] Replace hydraulic oil filter and PTO filter (if equipped) |
[ ] Check coolant conditioner |
| [ ] Take gearbox oil sample |
[ ] Take transmission oil sample |
| [ ] Take diesel fuel sample |
[ ] Take engine coolant sample |
| |
Comments:
|
|
Date:
|
Hour Meter Reading:
|
Maintenance Performed By:
|
| |
| Every 1000 Hours |
| |
| [ ] Drain and refill MFWD front axle housing oil (if equipped) |
[ ] Replace transmission oil filter |
| [ ] Drain and refill MFWD planetary housing oil (if equipped) |
[ ] Drain and refill hydraulic reservoir oil |
| [ ] Clean, pack, and adjust non-power front wheel bearings (if equipped) |
[ ] Clean engine crankcase vent tube |
| [ ] Drain and refill rear axle oil |
[ ] Check engine speed |
| [ ] Drain and refill transmission and torque converter oil |
[ ] Replace engine air filter elements |
| |
Comments:
|
|
Date:
|
Hour Meter Reading:
|
Maintenance Performed By:
|
| |
| Every 2000 Hours |
| |
| [ ] Adjust engine valve lash |
|
| |
Comments:
|
|
Date:
|
Hour Meter Reading:
|
Maintenance Performed By:
|