Change Engine Break-In Oil and Replace Filter (S.N. 888004- )

NOTE: Change after first 250 hours and then every 500 hours.

CAUTION: Prevent possible injury from unexpected machine movement. Never rely on transmission control lever (TCL) and gearshift lever to keep machine from moving. Always engage park brake to hold machine.

1. Run engine to warm oil. Park machine on a level surface. Engage park brake. Stop engine.

2. Remove engine oil drain plug (A). Allow oil to drain into a container.

3. Using a suitable filter wrench, turn engine oil filter (B) counterclockwise and remove from base. Clean mounting surfaces of base as necessary. Dispose of waste oil properly.

4. Apply a thin film of oil to sealing ring on new engine oil filter, and install by turning new filter clockwise by hand until gasket touches mounting surface. Torque an additional 1/2-3/4 turn with filter wrench.

5. Install engine oil drain plug.

6. Remove engine oil fill cap (C) and fill engine with oil to specification. See Diesel Engine Oil. (Section 3-1.)

Engine Oil - Specification

IMPORTANT: Before starting engine after a filter change, crank engine for 10 seconds without starting to fill new engine oil filter and pre-lubricate the turbocharger, if equipped.

7. Run engine for 2 minutes and then stop engine. Check for leaks around drain plug and filter, and tighten as necessary. Check oil level. See Check Engine Oil Level. (Section 3-4.)

A-Engine Oil Drain Plug
B-Engine Oil Filter
C-Engine Oil Fill Cap

VD76477,00014D2 -19-29MAR07-1/1