Change Rear Axle and Planetary Housing Oil (S.N. 888004-)

NOTE: Dispose of waste oil properly.

1. Drain rear axle and both planetary housings oil into a container using drain plugs (1 and 2). Install plugs.

Specification

2. Rotate wheel so plug (2) is above OIL LEVEL line (3) when line is horizontal as shown.

3. Remove rear axle check and fill plug (4) and fill with oil until level with bottom of fill plug hole. See Check Rear Axle and Rear Planetary Oil Level (S.N. 888004-). (Section 3-8.)

NOTE: It will take approximately 5 minutes for oil to settle into outer housing when oil is warm.

4. Wait 5-10 minutes for oil to settle, then check level again and add oil as necessary. If oil is cold, settle time may increase.

5. Install all plugs.

1-Rear Axle Drain Plug
2-Planetary Housing Drain and Fill Plug
3-Planetary Housing Oil Level Line
4-Rear Axle Check and Fill Plug

VD76477,00014F2 -19-12APR07-1/1