Loading and Unloading Dump Body

CAUTION: DO NOT operate dump body control lever unless transmission is in neutral (N) (or dumping in 1st or reverse). This practice can override the safety functions and could cause damage to machine and/or personal injury.

CAUTION: Serious injury or death can result from contact with electric lines. Never move any part of the machine or load closer to electric line than 3 m (10 ft) plus twice the line insulator length.

Be sure there is sufficient space for machine before entering confined areas.

Keep bystanders clear of machine loading or unloading area.

Do not operate too closely to quarry edges, ramp edges, quay edges and soft edges that may collapse under machine weight.

Be aware of other machines and personnel when entering or leaving loading or dumping area.

Loading

If a spotter is present, follow only his instructions.

Back up to a loading machine in a single, straight position so that you can maintain eye contact at all times with the operator of the loading machine.

Steer machine so that it stays straight. This gives a clear and unobstructed vision through rear view mirrors. It may be difficult to observe the spotter and the loading machines if machine is articulated and not in straight-ahead position

Stop machine on a firm, level surface.

Lower the dump body fully.

Do not overload machine.

Load machine evenly. An uneven load will cause tire and axle damage.

Unloading

If a spotter is present, follow only his instructions.

Back up to unloading site in a single, straight position so you can maintain eye contact at all times with the spotter.

Steer machine so it stays straight. You must have clear and unobstructed vision through rear view mirrors. If machine is articulated and not in straight-ahead position, it may be difficult to observe the spotter and the dumping action.