Clean and Inspect Hydraulic Reservoir Breather

1. Remove nuts (2) and clamp (3) from dump body heater support and pipe.

2. Remove access panel cap screws (1) and access panel (4).

IMPORTANT: DO NOT spray steam, water or cleaning solution directly at hydraulic reservoir breather. Spray could be forced into hydraulic reservoir.

NOTE: Hydraulic reservoir breather should be checked daily in adverse working conditions. The amount of dust and dirt encountered will determine the frequency of breather cleaning.

3. Clean dirt, dust, and debris from hydraulic reservoir breather and from surrounding area.

4. Inspect hydraulic reservoir breather for clogging, damage, and proper installation.

Replace hydraulic reservoir breather if it appears damaged or cannot be unclogged. (See Replace Hydraulic Reservoir Breather in Maintenance-Every 4000 Hours section.)

5. Install access panel and cap screws.

6. Install clamp and nuts to dump body heater support and pipe.

T147657B
T147656B


1-Access Panel Cap Screw (4 used)
2-Nut (2 used)
3-Clamp
4-Access Panel

OUO1043,0000E07 -19-30OCT01-1/1