Replace Auxiliary Water Separator Fuel Filter-If Equipped

1. Open air vent (7) and remove drain plug (5) to drain fuel into a suitable container. Dispose of fuel waste properly.

2. Disconnect heater connector (4) and water probe (3) if equipped.

3. Remove glass bowl (2).

4. Remove and replace filter element (1).

5. Install glass bowl and drain plug.

6. Fill fuel filter by using air vent and priming hand pump (6).

7. Connect heater connector and water probe if equipped.

8. Start engine and let it run for 1 minute. Check for leaks. Tighten glass bowl only enough to stop leaks.


1-Filter Element
2-Glass Bowl
3-Water Probe (if equipped)
4-Heater Connector
5-Drain Plug
6-Priming Hand Pump
7-Air Vent

TX1053385

Auxiliary Water Separator Fuel Filte

CP94658,0000176 -19-07JAN09-1/1