Using Attachment Mounting System-Electric Quik-Tatch (S.N. 131877 - )

Installing an attachment:

2. Lower boom until boom is resting on boom stops.

3. Disengage park brake.

4. Push and hold electric Quik-Tatch switch in unlocked position until lock pins are fully retracted. Indicator window (1) should be completely red.

5. Tilt mounting plates (2) forward.

6. Drive forward and raise boom. Guide top of mounting plates under attachment mounting brackets.

7. Raise and rollback mounting plates. Back of attachment should rest against front of mounting plate.

8. Lower boom until boom is resting on boom stops when attachment is fully supported.

9. Roll attachment out. Stop with bottom edge of attachment 50 mm (2 in.) from ground.

10. Press and hold electric Quik-Tatch switch in the locked position until lock pins are fully engaged. No red should be visible in indicator window.

11. Activate lift cylinders to raise attachment and extend bucket cylinders to tilt attachment at a slight downward angle so that the bottom of the Quik-Tatch is visible.

12. Visually inspect attachment mechanism to verify that pins are fully engaged in slots on back of attachment.

CAUTION: Prevent possible crushing injury from falling attachment. Be sure pins are engaged before operating boom and bucket. No red should be visible in the indicator window.

13. Connect hydraulic hoses of attachment (if equipped).

1-Indicator Window
2-Tilt Mounting Plates

DW90712,0000156 -19-14MAR07-1/2

Removing the attachment:

2. Lower boom until attachment is securely resting on ground.

3. Engage park brake, and stop engine.

4. Disconnect hydraulic hoses from attachment (if equipped).

5. Fasten seat belt.

6. Start engine, and disengage park brake.

7. Push and hold electric Quik-Tatch switch in unlocked position until lock pins are fully retracted. Indicator window on electric Quik-Tatch should be completely red.

8. Tilt mounting plate forward, and back machine away from attachment at the same time.

DW90712,0000156 -19-14MAR07-2/2