Starting the Engine

1. Fasten seat belt.

2. Be sure all drive and auxiliary hydraulic controls are in neutral.

3. Engage park brake.

4. Push engine speed control lever (1) forward to 1/3 position.

5. Turn key switch to run position, but do not crank engine.

6. Check instrument panel. Engine low oil pressure indicator will be lit until engine starts:

IMPORTANT: Avoid possible machine damage. Do not crank starter continuously for more than 30 seconds or you may damage starter.

Do not use ether or any other type of starting fluid on engines.

Do not tow the machine to start it, or damage to hydrostatic system will occur.

7. Turn key switch to start position.

8. Release key when engine starts. If engine does not start within 30 seconds, turn key switch to off position and allow starter to cool for 1 minute before trying again.

a. A warning light bulb check is performed each time machine is started.

IMPORTANT: To prevent damage of hydraulics and engine in temperatures below 0°C (32°F), run engine at low idle for 10 minutes before operating controls.

b. Always allow engine to warm up before applying a load.

T153263B


1-Engine Speed Control Lever

DW90712,00001D2 -19-13JAN09-1/2

9. Run at 1/3 speed for 30 seconds. Do not run at fast or slow idle. Do not accelerate rapidly during warm-up.

10. Operate machine at less-than-normal loads and speeds until engine is at normal operating temperature.

DW90712,00001D2 -19-13JAN09-2/2