|
Biodiesel is a fuel comprised of mono-alkyl esters of long chain fatty acids derived from vegetable oils or animal fats. Biodiesel blends are biodiesel mixed with petroleum diesel fuel on a volume basis.
Biodiesel users in the U.S. are strongly encouraged to purchase biodiesel blends from a BQ-9000 Certified Marketer and sourced from a BQ-9000 Accredited Producer (as certified by the National Biodiesel Board). Certified Marketers and Accredited Producers can be found at the following website: http://www.bq-9000.org.
While 5% blends are preferred (B5), biodiesel concentrations up to a 20% blend (B20) in petroleum diesel fuel can be used in all John Deere engines. Biodiesel blends up to B20 can be used ONLY if the biodiesel (100% biodiesel or B100) meets ASTM D6751 (US), EN 14214 (EU), or equivalent specification. Expect a 2% reduction in power and a 3% reduction in fuel economy when using B20.
John Deere approved fuel conditioners containing detergent/dispersant additives are recommended when using lower biodiesel blends, but are required when using blends of B20 or greater.
John Deere engines can also operate on biodiesel blends above B20 (up to 100% biodiesel) ONLY if the biodiesel meets the EN 14214 specification (primarily available in Europe). Engines operating on biodiesel blends above B20 may not fully comply with all applicable emissions regulations. Expect up to a 12% reduction in power and an 18% reduction in fuel economy when using 100% biodiesel. John Deere approved fuel conditioners containing detergent/dispersant additives are required.
The petroleum diesel portion of biodiesel blends must meet the requirements of ASTM D975 (US) or EN 590 (EU) commercial standards.
Biodiesel blends up to B20 must be used within 90 days of the date of biodiesel manufacture. Biodiesel blends from B21 to B100 must be used within 45 days of the date of biodiesel manufacture.
|
Request a certificate of analysis from your fuel distributor to ensure that the fuel is compliant with the above specifications.
Consult your John Deere dealer for approved biodiesel fuel conditioners to improve storage and performance with biodiesel fuels.
When using biodiesel fuel, the engine oil level must be checked daily. If oil becomes diluted with fuel, shorten oil change intervals. Refer to Diesel Engine Oil and Filter Service Intervals for more details regarding biodiesel and engine oil change intervals.
The following must be considered when using biodiesel blends up to B20:
-
Cold weather flow degradation
-
Stability and storage issues (moisture absorption, oxidation, microbial growth)
-
Possible filter restriction and plugging (usually a problem when first switching to biodiesel on used engines.)
-
Possible fuel leakage through seals and hoses
-
Possible reduction of service life of engine components
The following must also be considered when using biodiesel blends above B20.
-
Possible coking and/or blocked injector nozzles, resulting in power loss and engine misfire if John Deere approved fuel conditioners containing detergent/dispersant additives are not used
-
Possible crankcase oil dilution, requiring more frequent oil changes
-
Possible corrosion of fuel injection equipment
-
Possible lacquering and/or seizure of internal components
-
Possible formation of sludge and sediments
-
Possible thermal oxidation of fuel at elevated temperatures
-
Possible elastomer seal and gasket material degradation ( primarily an issue with older engines)
|