Electrical System

Symptom Problem Solution

Park Brake Will Not Disengage

Seat belt or seat switch is not activated

Fasten seat belt, and activate seat switch.

Unfasten and fasten seat belt to reactivate seat switch.

Park brake has not gone through the momentary down position (unlocked).

Push lower half of switch.

Park Brake Will Not Engage

Park brake is not in the up (locked) position

Push upper half of switch.

Starting Motor Will Not Turn

Battery terminals corroded

Check and clean as necessary.

Loose connection at starter or starter relay

Check all electrical connections.

Blown fuse

Replace fuse.

Battery dead or low charge

Check battery voltage, and charge as necessary.

Engine Cranks Slowly

Low battery input

Check battery voltage, and charge as necessary.

Loose or corroded battery cables

Inspect and clean or tighten.

Engine oil viscosity too heavy

Verify engine oil viscosity.

Battery Will Not Charge

Dead cell in battery

Replace battery.

Low engine speed or excessive idling

Increase engine rpm to raise alternator output.

Battery cables and terminals dirty

Clean cables and connections as necessary.

Fan/alternator belt loose or damaged

Check belt. Tighten if loose.

Lights Do Not Work

Blown fuse

Replace fuse.

Loose or bad bulb

Check bulb connection, or replace as necessary.

TX14740,00000CC -19-05APR07-1/2


Symptom Problem Solution

Battery Voltage Indicator Light Remains On With Engine Running

Loose or glazed alternator belt

Check belt. Tighten if loose. Replace if glazed.

Low battery input

Check battery voltage, and charge as necessary.

TX14740,00000CC -19-05APR07-2/2