Checking Battery Electrolyte Level (Maintenance Type Batteries Only)A maintenance-free battery is standard on machine. If a non-maintenance free battery has been installed, the following caution applies:
Wear eye protection, and avoid spilling or dripping electrolyte. Flush eyes with water for 15-30 minutes if acid is splashed into eyes. Get medical attention immediately. If acid is swallowed, get medical attention immediately. 1. Park machine.2. Open rear service door and engine cover. 3. Remove left side engine panel. 4. Clean battery with a damp cloth or rag. Keep dirt out of battery cells. 5. Remove battery caps. IMPORTANT: DO NOT fill cells to the bottom of filler neck (1). Electrolyte can overflow when battery is charged and cause damage. 6. Electrolyte (2) should be 6 mm (1/4 in.) above plates (3). 7. Add distilled water, if necessary, to battery cells. 8. Install battery caps. 9. Install left side panel, close engine cover and rear service door. |
|
CAUTION:
Sulfuric acid in battery electrolyte is poisonous. It is strong enough to burn skin, eat holes in clothing, and cause blindness if splashed into eyes.
TX14740,00000D4 -19-04NOV09-1/1 |