|
IMPORTANT:
Prevent possible machine damage. Using incorrect coolant mixture can damage radiator.
Do not operate engine without coolant.
Do not operate engine with plain water.
Use antifreeze approved for use in aluminum engines.
Do not exceed a 50% antifreeze mixture for coolant.
Do not pour coolant or water into radiator when engine is hot.
NOTE:
John Deere COOL-GARD
™
II Pre-Mix coolant is recommended when adding new coolant to cooling system.
Follow directions on container for correct mixture ratio.
1.
Open rear service door.
|
2.
Check condition of coolant system hoses. If new hoses are needed, see your authorized dealer.
3.
Fill cooling system slowly.
Specification
|
Cooling System
-Refill Capacity
|
6.6 L
|
7.0 qt.
|
4.
Install and tighten radiator cap.
5.
Start engine and run until engine reaches operating temperature, allowing entire system to be filled with coolant.
6.
Stop engine.
7.
Allow engine to cool.
8.
Refill recovery tank if necessary.
|