Raising Operator's Station

CAUTION: Prevent crushing injury from falling attachment. If machine is equipped with a demolition door or cab enclosure, it will be necessary to do the following:

Raise boom, engage boom lock, and rest boom on boom lock.

Open cab/demolition door.

NOTE: Operator's station can be raised with the boom resting on boom lock.

2. Remove nuts (1) (one on each side).

3. Using hand holds, raise operator's station, making sure steering levers fall forward. Continue raising operator's station all the way up so that gas spring cylinder locks are in place.

4. Ensure operator's station cylinder is locked by pulling forward on red cylinder lock (2).

5. To lower operator's station, push red cylinder lock (3) rearward to unlock cylinder.

6. Pull operator's station down until seated on mounting studs.

CAUTION: Prevent crushing injury from unexpected cab movement. Replace gas spring cylinder if:

Cylinder is cracked or damaged.

The operator's station is hard to lift.

NOTE: See your authorized dealer. NEVER attempt to repair a damaged gas spring cylinder.

7. Install washer and nut on operator's station mounting stud (one on each side). Tighten hardware to specification.

1-Nut
2-Cylinder Lock (locked position)
3-Cylinder Lock (unlocked position)

VD76477,0000073 -19-09JAN09-1/2

Specification

8. Disengage boom lock and lower boom.

VD76477,0000073 -19-09JAN09-2/2