|
NOTE:
It is normal for battery voltage indicator to light when glow plugs are active.
IMPORTANT:
Avoid possible machine damage. Do not crank starter continuously for more than 30 seconds, or the starter may be damaged.
Do not use ether or any other type of starting fluid on engines.
Do not tow the machine to start it, or damage to hydrostatic system will occur.
|
IMPORTANT:
To prevent damage to hydraulics and engine in temperatures below 0°C (32°F), run engine at low idle for 10 minutes before operating controls.
1.
Turn key switch to run position. If hydraulic oil temperature is below 16°C (60°F), glow plug light will stay on for 20 seconds as indicated by indicator light on monitor.
2.
After glow plug light goes off, turn key switch to the start position.
|