Operating Auxiliary Hydraulics-EH Controls

Auxiliary hydraulics area controlled by a roller (6) on the right EH control and a button (2) on the left EH control.

Activating auxiliary hydraulics:

• Push the roller (6) on the right EH control towards the front of the machine to supply oil to the male quick coupler.
• Push the roller (6) on the right EH control towards the back of the machine to supply oil to the female quick coupler.
• The further the roller (6) on the right EH control is pushed away from its neutral position, the faster the oil will flow in the respective direction.

Actuating the button (2) on the left EH control while the roller (6) on the right EH control is out of its neutral position allows the valve to be held on with full flow in the respective direction. The button and roller can then be released and flow will continue.

Actuating the button (2) on the left EH control a second time (or the roller on the right EH control) will cause the flow to stop. Roller (6) on the right EH control will need to be returned to its neutral position and in desired direction before flow can resume.

IMPORTANT: The roller must be in its neutral position when auxiliary hydraulics are not in use to prevent overheating of hydraulic oil.

1-Horn
2-Auxiliary 1 ON/OFF or SET
3-Auxiliary 3 A (optional installation)
4-Auxiliary 3 B (optional installation)
5-2 Speed
6-Auxiliary 1
7-Float
8-Auxiliary 2 A (optional installation)
9-Auxiliary 2 B (optional installation)

ER93822,0000082 -19-05FEB08-1/1