Storing Attachment

NOTE: Some of the following steps may not apply to your attachment.

1. Remove any grass clippings from MCS or bagger attachment.

2. Remove attachment from machine.

3. Clean attachment and driveline, if equipped, with water pressure from a hose.

4. Remove any shields if needed to clean out all debris.

5. Repair or replace worn, bent, or damaged parts. Tighten loose hardware.

6. Apply paint to painted surfaces where needed to prevent rust.

7. Apply thin coat of grease to blades or tines to prevent rust.

8. Lubricate any pivot points with engine oil to prevent rust.

9. Lubricate any grease points.

10. IMPORTANT: Abrasive surfaces can damage attachment. Store attachment on non-abrasive surface or on wooden blocks.

    If storing attachment outdoors, block up attachment if possible and place a waterproof cover over it.