Tighten Hardware and Adjust Belt

TCAL45136-UN-10APR13

1. Install blower front pivot pin (A) and secure with quick-lock pin (B) in front mounting bracket.

2. 
   TCAL45137-UN-10APR13

   Swing blower into position and align hole in blower bracket (C) with hole in blower support bracket (D). Install carriage bolt (E) and handle assembly (F).

---




3. Install bracket (G) using two carriage bolts and nuts (H).

4. Tighten hardware on rear mounting brackets.

5. Connect primary drive belt from blower to drive sheave on deck.

6. 
   TCAL45138-UN-10APR13

   Adjust primary belt.

---




7. Tighten nut (I) on tension rod until spring (J) length is within specification.

   Item	Measurement	Specification
   Tension Rod Spring	Length	150 mm +/- 10 mm (6 in. +/- 0.4 in.)