Using Operator Controls

Using Run Switch

Push run/stop toggle switch forward to run engine.

• Pull run/stop toggle switch back (toward operator) to stop engine.

Using Operator Presence Bail

CAUTION: Avoid injury! This machine is equipped with an operator presence system to protect the operator and bystanders. Do not attempt to alter the function of the operator presence system.

IMPORTANT: Avoid damage! Do not attempt to move machine using operator presence bail. Bail is not designed to support machine weight.

The operator presence bail stops all moving parts when released.

The operator presence bail when squeezed with handlebar permits engagement of the clutch lever.

Using Travel Clutch Lever (Forward Travel)

1. Hold operator presence bail to handlebar.

2. Push travel clutch lever forward to engage drive clutch.

3. Release bail to stop travel.

Using Park Brake Lever

Release operator presence bail and pull brake lever back to stop mower movement.

Using Throttle Lever

Use throttle lever to adjust engine speed and rate of travel.

Pull lever back (toward operator) to reduce engine speed.

Adjust throttle lever depending on rate of travel, cutting height, and ground contour.

Using Choke Lever

Move choke lever left toward the decal for the choke position.

Using Fuel Shut-Off Valve

This unit is equipped with a 2-position fuel shutoff valve. Slide lever to the right to open or to the left to close the fuel shutoff valve.

Closed (OFF) position:

• When performing any type of service.
• When transporting.
• During storage.

Open (ON) position

• Fuel shutoff valve must be in the full open (ON) position for proper fuel delivery to the engine.

Using Greens Tender Conditioner (GTC) Handle

Turn handle up in the (detent) position for run.

Turn handle down in the (detent) position for off.