Instrument Panel

TCAL45006-UN-14MAY13

A - Fuel Gauge

B - Tachometer

C - Engine Coolant Temperature Gauge

D - Hour Meter

E - Four Wheel Drive (4WD) Indicator (If equipped)

F - PTO Indicator

G - Engine Coolant Temperature Indicator

H - Glow Plug Circuit Indicator (Diesel Model)

I - Speedometer LED Display

J - Battery Low Voltage Indicator

K - Park Brake Indicator

L - Engine Oil Pressure Indicator

M - Check Engine Indicator - Malfunction Indicator Lamp (MIL) (Gas Models)

N - Not Used

Fuel Gauge (A) shows approximately how much fuel is in the fuel tank.

Tachometer (B) is an instrument used to determine speed. Engine speed is shown in 100s. Example: If indicator is pointing at 20 (20 x 100 = 2000 rpm).

Engine Coolant Temperature Gauge (C) will indicate if engine temperature becomes excessive. If the gauge indicator needle moves all the way into the red zone, stop vehicle engine immediately and determine cause.

Gas Models Only - Engine RPM's and power will automatically be reduced when indicator needle is sustained for 10 seconds or more within the red zone.

Hour Meter (D) shows the approximate number of hours the engine has run. Use the hour meter and the Service Interval Chart to determine when the vehicle will need service.

Four Wheel Drive (4WD) Indicator (If equipped) (E) is visible only when lighted and will illuminate when the four wheel drive (4WD) is engaged.

PTO Indicator (F) is visible only when lighted and will illuminate when the hydraulic PTO lever is engaged.

Engine Coolant Temperature Indicator (G) will illuminate when the engine coolant approaches a dangerously hot temperature. Reduce engine to idle speed. Check the engine coolant level and make sure air flow to the radiator is not obstructed. Continued operation may cause higher temperatures resulting in damage.

Gas Models Only - Engine RPM's and power will automatically be reduced when light is illuminated.

Glow Plug Indicator (Diesel Model) (H) is visible only when lighted and will illuminate when the key switch is turned to the run position. The indicator light should go off approximately 3 seconds after the key switch is turned to the run position. This indicates that the engine glow plugs are on and preheating the engine combustion chamber.

Speedometer LED Display (I) will illuminate when the key switch is turned to the run position. This LED display indicates vehicle speed.

Battery Discharge Indicator (J) will illuminate when the key switch is turned to the run position. The indicator should turn off once the engine is started; if it continues to illuminate, the alternator may not be producing adequate current. Stop engine and determine cause.

Park Brake Indicator (K) will illuminate when the park brake is locked.

Engine Oil Pressure Indicator (L) will illuminate when engine oil pressure is low. If lamp glows when engine is running, stop engine immediately. This is an indication that the engine may be low on oil, or major engine damage may have occurred.

Check Engine Indicator - Malfunction Indicator Lamp (MIL) (Gas Models) (M) will illuminate at startup but will go off. If lamp glows when engine is running, stop engine immediately and determine cause.