Using Governor Mode

NOTE: To allow for proper governor engagement keep foot off the accelerator pedal when beginning operation in the governor mode.

1. Lock vehicle park brake.

2. Start vehicle engine.

Engage Governor

1. 
   TCAL45013-UN-14MAY13

   Move clamp lever (A) to UNLOCKED position (B).
   • Throttle/governor selector T-handle (C) will drop to the lowest SLOW (t) position.
   
   

---




2. Pull out T-handle (C) and rotate T-handle to GOVERNOR MODE (D) with the pointer (E) facing left. Release T-handle.

3. NOTE: Use the vehicle tachometer to monitor engine speed. Refer to each attachment operator’s manual if a set RPM is required for attachment operation.

   Push down accelerator pedal to increase engine RPM.

4. With accelerator pedal held in place at the desired RPM level, lower clamp lever (A) to LOCKED position (F).

   • If accelerator pedal is released, it will return to the raised position and engine RPM will return to idle.
   • If the accelerator pedal is depressed, the engine will be restricted to the set RPM, but will operate at any RPM below the maximum set by throttle/governor selector.
   • If T-handle is moved to the DISENGAGED VERTICAL MODE and the clamp lever remains in the LOCKED position, the preset position of the governor will be maintained. Return T-handle to GOVERNOR MODE when operation of the vehicle at the preset RPM is desired.
   • When set speed is determined, unlock park brake and begin vehicle travel.
   
   

Disengage Governor

1. Pull out the throttle/governor selector T-handle and rotate T-handle to DISENGAGED VERTICAL MODE (pointer up). Release T-handle.

2. Move clamp lever to the UNLOCKED position.

3. Move T-handle to the highest FAST position and hold.

4. Lower clamp lever to the locked position.