Changing Engine Oil and Filter

IMPORTANT: Avoid damage! Change the oil more often if the vehicle is used in extreme conditions:

• Extremely dusty conditions.

• Frequent slow or low-speed operation.

• Frequent short trips.

1. Run engine to warm the oil.

2. Raise attachment to service position. (See Using the Lift Cylinder Safety Support in the Safety section.)

3. Park vehicle safely. (See Parking Safely in the Safety section.)

4. Place container under the oil drain location.

5. 
   TCAL45033-UN-14MAY13

   Diesel Engine

   
   TCAL45034-UN-14MAY13

   Gas Engine

   Remove drain plug (A) located under the left side of the diesel engine and under the right side of the gas engine.

---




6. 
   TCAL45035-UN-14MAY13

   Diesel Engine

   
   TCAL45036-UN-14MAY13

   Gas Engine

   Remove oil filter (B).
   • Locate filter under the right side of the engine.
   • Turn filter counterclockwise to remove.
   
   

---




7. Apply a film of clean engine oil on gasket of new filter.

8. Install oil filter.

   • Turn filter clockwise until gasket makes contact with mounting surface. Tighten 1/2-3/4 turn after gasket contact.
   
   

9. Install oil drain plug. Do not overtighten.

10. 
    TCAL45037-UN-14MAY13

    Diesel Engine

    
    TCAL45038-UN-14MAY13

    Gas Engine

    Remove oil fill cap (C) on top of engine.

---




11. Add recommended fluid.

12. Install oil fill cap.

13. Start engine and run at idle for approximately two minutes. Check for leaks. Fix any leaks before operating.

14. Stop engine.

15. After approximately two minutes check engine oil level. Add oil if necessary.

16. Lower attachment.