Removing Machine From Storage

1. Check tire pressure.

2. Check engine oil level.

3. Check battery electrolyte level, if your battery is not maintenance free. Charge battery if necessary.

4. Install battery.

5. On gas engines: Check spark plug gap. Install and tighten plugs to specified torque.

6. Lubricate all grease points.

7. Open fuel shut-off valve, if your machine is equipped.

8. Be sure all shields and guards or deflectors are in place.

9. Run the engine 5 minutes without any attachments running to allow oil to be distributed throughout engine.

10. Clean out above hydraulic PTO control valve under seats. Apply hydraulic oil on both spools where they enter the valve block.