Come Home Mode

Come Home Mode allows the operator to move a tractor having mechanical problems.

NOTE: A 10A fuse (not supplied) is required to enter this mode. This fuse is referred to as the Come Home fuse in this procedure.

The Transmission Control Unit (TCU) must detect the Come Home fuse on initial ignition start-up before it enters come home mode. If the Come Home fuse is inserted after ignition start-up, the ignition must be powered off and back on before Come Home Mode will be activated.

Hydrostatic Transmission: The pedals must be in neutral position after Come Home Mode is activated before any motion is commanded.

PowrReverser Transmission: Reverser lever on dash must be in neutral position after Come Home Mode is activated before any motion is commanded.

Inserting the Come Home fuse generates a DTC (523966.01—Come Home Mode Procedure Detected). This code stays active until the Come Home mode fuse is removed.

Perform the following to enter the tractor into Come Home Mode:

  1. With key switch OFF, insert the Come Home fuse (10A) into F03 in the tractor fuse panel.

    NOTE: For more information on fuse location, see “Locating Fuses and Relays”.

  2. Start engine.

  3. When the instrument cluster displays “Seat”, toggle the seat switch (operator gets out of the seat and sits down again).

  4. Display beeps five times and the Service Indicator Light illuminates.

  5. Move tractor.

Vehicle Response in Come Home Mode:

  • PTO Operation Disabled
  • Hitch Assist Disabled
  • LoadMatch Disabled
  • MotionMatch Disabled
  • eThrottle Disabled
  • Cruise Control Disabled
  • Creep2Reposition Disabled
  • Shuttle Shifts Disabled
  • Fault Codes Ignored
  • Transmission calibration is not permitted

JC48530,00000B4-19-20190927