Operate Rear PTO (Operator off Seat)

NOTE: Engine starts with PTO switch engaged, but PTO switch must be cycled off and on again before PTO engages.

Engaging the PTO

1. Sit on the operator seat.

2. Lock the park brake.

3. Move the range-shift lever to the neutral “N” position.

4. Start the engine.

5. Set engine speed to 1500 rpm or less.

6. 
   LV27297-UN-08MAR17

   A - PTO Lever

   B - Mid PTO Only

   C - Mid and Rear PTO

   D - Rear PTO Only

   Move the PTO lever (A) to Position (D) - Rear PTO only.
   • Position (B) - Mid PTO only.
   • Position (C) - Mid and Rear PTO.
   • Position (D) - Rear PTO only.
   
   

---




7. 
   LV26740-UN-04NOV16

   Engage the PTO by pressing switch (A) forward.

---




8. Push and hold the PTO switch in the engaged position for at least 2 seconds. “SEAt” is shown in the display.

9. Exit the seat and release the PTO switch. After exiting, “StAt Pto Act” is shown on the display.

   NOTE: If the park brake is not engaged and the range-shift lever is not in “N” , the information display with show “APPLY Pb” and/or “ShiFt to nEut”. These conditions must be met before the out of seat PTO will activate.

   After exiting seat, if the seat switch is reengaged (operator sits in the seat) and then disengaged (operator leaves the seat), the PTO will automatically disengage. “out oF SEAt” displays on the information display.

10. Adjust the hand throttle forward to the desired speed for the implement used.

Disengaging the PTO

1. Adjust engine rpm to low idle.

2. Push PTO switch rearward to the disengaged/off position.