Stop Engine

Normal Stop

1. CAUTION: Avoid Injury! Couple the brake pedals together when driving at higher speeds.

   Position the machine on a firm, level surface.

2. Stop motion by smoothly removing pressure from forward or reverse travel pedals.

3. Disengage the PTO.

4. CAUTION: Avoid Injury! Check that the area is clear of bystanders before lowering implements to the ground.

   Lower implements to the ground.

5. CAUTION: Avoid Damage! Do not stop the engine immediately after a hard or extended operation. Prevent heat buildup by running the engine at low idle for 2 minutes.

   Set hand throttle to the low idle position. Allow the engine to idle for 2 minutes.

6. CAUTION: Engage the park brake and move the transmission range lever to a position other than N (neutral) before leaving the machine unattended.

   Apply the park brake.

7. Turn key switch to OFF position.

8. Remove key.

9. Wait for the engine and all moving parts to stop before leaving the operator station.

Emergency Stopping

1. Remove foot from forward or reverse pedal.

2. Depress brake pedal.

3. Turn key switch to OFF position. Do not release the brake pedal until all moving parts have stopped.

4. Apply the park brake.