Adjusting Cutting Height-Semi-Mount

1. Position machine on flat level ground.

NOTE: Blade cut is approximately 25.4 mm (1 in.) higher than skid shoes.

2. Adjust cutting height as desired using tractor rockshaft control and SCV lever. With tailwheels in the "trailing" position, make sure skid shoes are parallel to the ground.

3. Set lower limit on tractor rockshaft control. (See your tractor Operator's manual.)

AG,OUMX005,1016 -19-04AUG99-1/2

NOTE: Cylinder stops (provided with machine) are used to return cutter to same cutting height after cylinder is extended for any reason. (i.e. Transporting) Various sizes of cylinder stops are available.

4. Install the correct number/size of cylinder stops (A) around lift cylinder rod as required to attain desired cutting height.


A-Cylinder Stops

W03581
W03583

AG,OUMX005,1016 -19-04AUG99-2/2