Replacing Skid Shoes

causym CAUTION: When servicing skid shoes, it will be necessary to work underneath cutter. Be sure to support cutter frame at all four corner locations with safety shop stands to prevent accidental lowering. Do not position safety stands under axle or wheel supports because these components can rotate.

1. Lower cutter onto safety shop stands.

TS260

AG,OUMX005,1031 -19-09AUG99-1/2

NOTE: Skid shoes (A) are welded on.

2. Remove existing skid shoe with a grinder.

3. Weld on a new skid shoe.

4. Apply green John Deere paint to exposed metal areas.

5. Raise cutter and remove safety stands.

6. Lower cutter to the ground.


A-Skid Shoe

W03653

Skid Shoe-Right-Hand Side Shown

AG,OUMX005,1031 -19-09AUG99-2/2