Every 50 Hours

Swivel Hitch-If Equipped (Pull-Type)
W03601

AG,OUMX005,1035 -19-09AUG99-1/8

Bellcrank (Pull-Type)
W03602

AG,OUMX005,1035 -19-09AUG99-2/8

W03603

Right-Hand Side Hitch Arm-Rear
W03604

Right-Hand Side Hitch Arm-Front
Hitch Arms (Semi-Mount with Hydraulic Offset) (Left and Right-Hand Side)

AG,OUMX005,1035 -19-09AUG99-3/8

W03608

Right-Hand Side, Semi-Mount Shown
W03609

Left-Hand Side, Semi-Mount Shown
Axle Beam Pivots (Pull-Type and Semi-Mount)

AG,OUMX005,1035 -19-09AUG99-4/8

Tailwheel Spindles (Lift-Type and Semi-Mount)
W03657

Lift-Type

W03599

Semi-Mount, MX10 Shown

AG,OUMX005,1035 -19-09AUG99-5/8

Tailwheel Bearings
W03610

AG,OUMX005,1035 -19-09AUG99-6/8

Tightening Gear Case Mounting Hardware

Before servicing machine refer to LUBRICATING AND MAINTAINING MACHINE SAFELY at the beginning of this section.

IMPORTANT: To help prevent structural damage caused by loose hardware, tighten gear case hardware as specified. Check torque after first 8 hours of use and every 50 hours thereafter.

NOTE: Use an assistant to aid in tightening procedure.

Access holes are provided in bottom of blade holder pan. Manually rotate blade holder to align holes with gear case mounting hardware.

Tighten gear case mounting hardware to specifications using a wrench (A), torque wrench (B) and a torque multiplier if necessary.

Specification

Gear Case Mounting Hardware -Torque 610 N·m (450 lb-ft)

W15390


A-Wrench
B-Torque Wrench

AG,OUMX005,1035 -19-09AUG99-7/8

Tightening Blade Holder Hardware

Before servicing machine refer to LUBRICATING AND MAINTAINING MACHINE SAFELY at the beginning of this section.

IMPORTANT: Operating with a loose blade holder can cause damage to the splined connection. To ensure proper seating between the blade holder and output shaft, two initial tightenings are required. Retighten after one hour and again after the first day of operation. In severe cutting conditions, recheck torque every 50 hours.

Tighten blade holder hardware to specifications using a torque wrench (C), torque multiplier (B) and a long piece of pipe (A). Position pipe into a corner of the machine.

Specification

Blade Holder Hardware -Torque 610 N·m (450 lb-ft)


A-Piece of Pipe
B-Torque Multiplier
C-Torque Wrench

W03660

AG,OUMX005,1035 -19-09AUG99-8/8