OMW45015: MX8 and MX10 Rotary Cutters, Block File: AG_OUMX005_797_19

causym CAUTION: To avoid personal injury, use locking pins to hold drawbar stationary when operating PTO driven implements.

1. Remove locking pins (A) and move drawbar to center position (shown).

2. Install locking pins.

3. Remove clevis assembly, if equipped.

A-Locking Pins

John Deere 7000 Series Tractor Shown

AG,OUMX005,797 -19-01JUN99-1/2

IMPORTANT: If shaft adapter is used to reduce 1-3/4 in. diameter shaft to 1-3/8 in. diameter shaft, measure from end of adapter to drawbar hole.

Failure to conform to the following setup dimensions can result in serious powerline damage.

4. If drawbar is offset, turn drawbar so offset is down, as shown.

NOTE: A tractor drawbar adjustment decal is located on left-hand side of pedestal.

5. Set drawbar length (A) to the following dimensions:

PTO Shaft (1-3/8 in. Diameter)	Dimension (A) mm (in.)
540 rpm	356 (14)
1000 rpm	406 (16)

A-Dimension, Drawbar Length

AG,OUMX005,797 -19-01JUN99-2/2