OMW45015: MX8 and MX10 Rotary Cutters, Block File: AG_OUMX005_807_19

Install Axle Supports, Spindles and Tailwheels

NOTE: Machine is equipped with two tailwheel supports. Perform the following procedures on BOTH tailwheel supports. Right-hand side, MX10, shown.

1. Install axle support (A) on beam using two M20 V-bolts and four lock nuts. Leave lock nuts loose.

2. Slide axle support along beam until centered on beam as shown or position at desired wheel spacing. Tighten lock nuts to specifications.

Specification

V-Bolt Lock Nuts -Torque

542 N·m

(400 lb-ft)

A-Axle Support

AG,OUMX005,807 -19-03JUN99-1/3

3. Apply multipurpose grease to pivoting surface of spindle (A).

4. Install spindle (A), two 46 x 63.5 x 2 mm washers (B) and 10 x 65 mm spring pin (C).

A-Spindle
B-Washers, 46 x 63.5 x 2 mm
C-Spring Pin, 10 x 65 mm

AG,OUMX005,807 -19-03JUN99-2/3

5. Install tailwheel with four 1/2 x 1-1/2 in. round head bolts and lock nuts. Install lock nuts opposite side of spindle hub. Tighten lock nuts to specifications.

Specification

Tailwheel Lock Nuts -Torque

110 N·m

(80 lb-ft)

6. Repeat on opposite side.

AG,OUMX005,807 -19-03JUN99-3/3