|
Excessive wear
|
Cutting too low in abrasive soil.
|
Increase cutting height.
|
|
Bolt loosening
|
Inadequate torque on blade bolts.
|
Tighten blade bolts. (See REPLACING BLADES in Service section.)
|
|
|
Cutting in very wet conditions.
|
Do not operate in these conditions.
|
|
|
Cutting too low, scalping ground.
|
Increase cutting height.
|
|
|
Cutting too low in rocky conditions.
|
Increase cutting height.
|
|
Breakage
|
Cutting too low in rocky conditions.
|
Increase cutting height.
|