Install Rear Safety Shield (Chain)-MX10

NOTE: Perform the following procedures on both side plates. Right-hand side is shown.

1. Cut out section (A) using a hack saw.

2. File edges smooth.

3. Apply green John Deere paint to exposed metal areas.

A-Cut-Out

AG,OUMX005,874 -19-21JUN99-1/2

A-Left-Hand Side Shield
B-Lock Nut, M10 (23 used)
C-Flange Head Cap Screw, M10 x 30 mm (23 used)

D-Left-Hand Shield
E-Right-Hand Shield

F-Right-Hand Side Shield
G-Rod (2 used)

H-Chain Link (90 used)

Tighten all mounting hardware AFTER all shields have been installed.

AG,OUMX005,874 -19-21JUN99-2/2