|
Excessive Wear on Bucket Cutting Edge
|
Too much down pressure when scraping on concrete surface.
|
Replace cutting edge. Use FLOAT position.
|
|
Bucket Cutting Edge Bent Down
|
Edge has contacted a solid object while forward scraping with bucket dumped more than 15° below level.
|
Position bucket at a 0-15° below level to protect the cutting edge while forward scraping.
|
|
|
Lifting loads concentrated on bucket edge.
|
Distribute loads over wider area.
|
|
Bucket Cutting Edge Bent Up
|
Edge has contacted a solid object while scraping or leveling rearward with bucket dumped more than 40° below level.
|
Position bucket at 40° or less below level to protect the cutting edge while rearward leveling. Use FLOAT to reduce down pressure.
|