Setting Control Lever Stops-SCV Operated Loader on 50, 55, and 60 Series Tractors

CAUTION: Help prevent personal injury or death caused by objects falling on the operator. Poppet type selective control valves have an automatic cylinder extend position (detent) that must be locked out for loader operation. Unintentional movement of the control lever to the detent position may cause the loader to raise to full height unexpectedly and the load to fall back on the operator.

NOTE: A rubber (A) strip is provided to make stops. Cut strip to length needed and insert in lever slot.

1. Insert stops ahead and behind bucket control lever (Number 2 SCV) to prevent lever from moving to automatic extend and retract position.

2. Insert a stop behind lift control lever (Number 1 SCV) to prevent lever from moving to automatic extend. Position a stop ahead of the lever only if FLOAT is not desired.

3. Adjust selective control valves for fastest rate of operation. (See your tractor Operator's Manual.)

A-Rubber Stop

OUO6038,000144E -19-17SEP01-1/1